You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
LibreCAD AppImage
Linux / Debian 12 based distro / GTK based DE
QT5 5.15.8
Couple requests regarding keycodes text that shows up in command line.
1.) When using keycodes mode, when you type in a command it shows the following item in the command line
"Accepted Keycode:"
was wondering if it could be considered to change this to the following instead
"Keycode:"
This is makes each item a simpler name, similar to how LC uses "Command:"
Also all keycodes are accepted, because if they are not, the command just does not get activated.
2.) When using keycodes, it also does not give any indication of the command being run, like how regular "Command:" does
Maybe can add the command similar to how regular commands do?
Example
Command: l (line)
Thank You
The text was updated successfully, but these errors were encountered:
LibreCAD AppImage
Linux / Debian 12 based distro / GTK based DE
QT5 5.15.8
Couple requests regarding keycodes text that shows up in command line.
1.) When using keycodes mode, when you type in a command it shows the following item in the command line
"Accepted Keycode:"
was wondering if it could be considered to change this to the following instead
"Keycode:"
This is makes each item a simpler name, similar to how LC uses "Command:"
Also all keycodes are accepted, because if they are not, the command just does not get activated.
2.) When using keycodes, it also does not give any indication of the command being run, like how regular "Command:" does
Maybe can add the command similar to how regular commands do?
Example
Command: l (line)
Thank You
The text was updated successfully, but these errors were encountered: